Skip directly to content

Universal All Purpose Floor Kit

on Sat, 09/27/2014 - 23:07

After many requests for FB for cars other than Fords and Chevys, We finally had time to design and manufacture an All Purpose Floor Kit.
The one thing we noticed over the years is that most cars look remarkably alike without the floor pans. The exception being width and outside perimeter shape of the different bodies.  With this in mind, we designed the Kit from the center line out.  There are (2) Kits available: #901030 - Front  and #901035 - Rear

#901030 - Front  The Front Kit Starts at the FW and goes back towards the rear approximately 22” to 26” depending on your car’s Toe Plate Angle. The front section consists of the Toe Plates, Tranny Hump, & the Tunnel and the Right and Left Floor Pans and a Tunnel Section for a length of 32”.  

#901035 - Rear. The Rear Kit attaches to the Front Kit and it will match up to more Rear Kits allowing you to make your FB as long as you need by purchasing more Rear Sections.

The concept is that you locate the Center Line of your Car and put the Floor Pans into place followed by the Tunnel if necessary. These Pans are extra-large so you can trim the outer edge to the shape of your car’s floor. Both Kits are made of 16 Gauge Cold Rolled Steel and come with hardware and sealer.

Remember, an All Purpose Floor Kit is designed for no one particular car. It is designed to give you enough materials so that combined with a little effort on your part; You Can Have A Truly Bitchin FB In Your Vehicle.